prostep ivip WIKI

Site Tools

tutorials:vec:wires

Differences

This shows you the differences between two versions of the page.

 tutorials:vec:wires [2019/03/07 13:50]4soft.becker created tutorials:vec:wires [2019/03/07 13:52] (current)4soft.becker Both sides previous revision Previous revision 2019/03/07 13:52 4soft.becker 2019/03/07 13:50 4soft.becker created2018/11/28 17:30 4soft.becker 2018/11/28 17:29 4soft.becker created 2019/03/07 13:52 4soft.becker 2019/03/07 13:50 4soft.becker created2018/11/28 17:30 4soft.becker 2018/11/28 17:29 4soft.becker created Line 21: Line 21: This third WireElementSpecification defines the type of grouping by a WireGroupSpecification. In the example the Grouping is the definition of a twist of the two Cores. It also defines the insulation around the two SubWireElements by an InsulationSpecification. Since the defined wire has a conductive shield as well, the described WireElementSpecification references a ShieldSpecification,​ too. The cross section area in the ShieldSpecification defines the nominal cross section area of the conductive material used in the shield. This third WireElementSpecification defines the type of grouping by a WireGroupSpecification. In the example the Grouping is the definition of a twist of the two Cores. It also defines the insulation around the two SubWireElements by an InsulationSpecification. Since the defined wire has a conductive shield as well, the described WireElementSpecification references a ShieldSpecification,​ too. The cross section area in the ShieldSpecification defines the nominal cross section area of the conductive material used in the shield. - <- component_description_basics | Previous ^ start|Table of Content ^ next |Next -> + <- component_description_basics | Previous ^ start|Table of Content ^ connectors ​|Next -> {{tag>​tutorials:​vec:​v113 part_master instantiation}} {{tag>​tutorials:​vec:​v113 part_master instantiation}}