DefaultDimension

A Placement defines the way how a component is associated to the topology. The following sections contain examples about the different types of placements. Semantic Difference: SegmentLocation vs. NodeLocation Disclaimer: This page or section is currently under review by the community.

Default Dimensions

Default Dimensions

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically, they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).

Default Dimensions DefaultDimension can be used to define standard tolerances that apply to certain elements. Typically they are represented in a document or a drawing as a table (e.g. for wires with length < x; tolerance a, x < length < y; tolerance b and so on).