Placement and Dimensions
Placement and Dimensions A PlacementSpecification is used to define the Placement of OccurrenceOrUsages in a topology as physical elements that build this topology and to define …
•
2 min read
Placement and Dimensions A PlacementSpecification is used to define the Placement of OccurrenceOrUsages in a topology as physical elements that build this topology and to define …
Module Lists and -Families In addition to the CompositionSpecification and the PartStructureSpecification, the VEC defines two other concepts to control occurrences, especially …
Assemblies, Modules and Harness (Configurations) The VEC composite part concept has four key classes: the PartStructureSpecification, the PartWithSubComponentsRole, the …
Instances of Labels If a component is labeled in its concrete usage, label informations are defined with the LabelingRole.
Instances of Placeable Components The diagram shows the mapping between the part master data of a PlaceableElement (partly displayed on the left side) and the corresponding …
Instances of undefined Components In some cases, it is necessary to specify and to use a component which is not defined in detail by the VEC. The recommended approach in such a …
Instances of Fixings, Cable Ducts, Cable Ties and Similar The diagram shows the mapping between the part master data of fixings and cable ducts (partly displayed on the left side) …
Instances of Wire Protections The diagram shows the mapping between the part master data of a wire protection (partly displayed on the left side) and the instance specific …
Instances of EE-Components The diagram shows the mapping between the part master data of an EE-component (partly displayed on the left side) and the instance specific information …