WireElementReference

This Implementation Guideline covers the various aspects of a correct wire representation in the VEC for different scenarios and variants of wires. It covers both multi cores and single cores.

There are various locations in the VEC model where structures / patterns are defined and used / instantiated somewhere else (e.g. a connector with its slots and cavities). In most cases, the elements in the definition of a structure have corresponding elements in the instancing (e.

A wide range of different systems, supporting different use cases, are used in the process of wiring harness development. All of them might have a VEC-Interface for input & output, so sooner or later the question arises “What are the expectations for the behavior of those interfaces?

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).

Instances of Wires The diagram shows the mapping between the part master data of a wire (partly displayed on the left side) and the instance specific information (displayed on the right side).

Routing A RoutingSpecification is a container for various Routings. Each Routing specifies a dedicated Path as an ordered list of TopologySegments through which the referenced RoutableElement is routed. A RoutableElement can either be a Connection or a WireElement (which can alternatively belong to a PartUsage or a PartOccurrence).

Routing A RoutingSpecification is a container for various Routings. Each Routing specifies a dedicated Path as an ordered list of TopologySegments through which the referenced RoutableElement is routed. A RoutableElement can either be a Connection or a WireElement (which can alternatively belong to a PartUsage or a PartOccurrence).

Routing A RoutingSpecification is a container for various Routings. Each Routing specifies a dedicated Path as an ordered list of TopologySegments through which the referenced RoutableElement is routed. A RoutableElement can either be a Connection or a WireElement (which can alternatively belong to a PartUsage or a PartOccurrence).

Wiring Specification The VEC model breaks down the information that is usually included on an electrical system wiring plan into three aspects: part usage information, contacting information and mating information.