Specification for the definition of cavity plugs that apply to more than one cavity. A cavity plug is a water tight non-electrical object to fill an empty cavity. MultiCavityPlugs are formed to fit into one connector / slot and to seal more than one cavity at once. Normally there are different variants of these MultiCavityPlugs that can seal a connector in different pinning scenarios. The cavities that are plugged by a MultiCavityPlug are defined with a SealedCavitiesAssignment.
Specifies a unique identification of the specification. The identification is guaranteed to be unique within the document containing the specification. Over all VEC-documents a Specification-instance can be trusted to be identical if the DocumentVersion-instance is the same (see DocumentVersion) and the identification of the Specification is the same.
Specifies additional, human readable information about the specification.
The specialPartType allows the specification of subclassifications for a PartOrUsageRelatedSpecification (e.g. different types of connector housings).
Specifies a range of valid cavity diameters to which the cavity seal fits.
Specifies the hardness of the cavity seal.
Specifies the sealing class of the cavity seal.
Defines the geometry of the cavity sealing.
This attribute is defined as an OpenEnumeration.
Defines a list of terminal types that are compatible to this CavitySealSpecification. This defines as well the compatible cavities, since a plug is normally used when no terminals are present.
References the SealedCavitiesAssignments that are valid for this MultiCavityPlug. One individual SealedCavitiesAssignment is used for each connector housing that matches witch this MultiCavityPlug.