BoundingBox

Note: There is a newer version of this specification see VEC 2.1.0

The bounding box is used to define a cuboid (box) that can contain a described part completely. Therefore, it is a simplified representation of the bounding volume and represents a definition of the maximum volume occupied by the part.

It is valid to use the BoundingBox to describe the dimensions of a component, even if not all dimensions are known (e.g. only length and width). However, it must be possible to transform such a partial bounding box into a complete bounding box by adding the missing dimensions.

General Information

AttributeValue
Ownerphysical_information
Applied Stereotype
Base Classifier
Is Abstractfalse
Derived Classifiers

Attributes

NameTypeMult.DescriptionOwning Classifier
xNumericalValue0..1

Defines the extent of the bounding box in the direction of x (length).

BoundingBox
yNumericalValue0..1

Defines the extent of the bounding box in the direction of y (width).

BoundingBox
zNumericalValue0..1

Defines the extent of the bounding box in the direction of z (height).

BoundingBox

Incoming Relations

TypeMult.RoleMult.Description
GeneralTechnicalPartSpecificationboundingBox0..1

Defines the bounding box of the part.

Previous