Note: There is a newer version of this specification see VEC 2.0.2
Specification for the definition of open wire ends. An open wire end is an end of wire located at a specific location in the harness. Open wire ends are not connected to some other component, in contrast to regular connectors or ring terminals. Only one wire is ending at a single open wire end, otherwise it would be a splice.
Specifies a unique identification of the specification. The identification is guaranteed to be unique within the document containing the specification. For all VEC-documents a Specification-instance can be trusted to be identical if the DocumentVersion-instance is the same (see DocumentVersion) and the identification of the Specification is the same.
Specifies additional, human readable information about the specification.
The specialPartType allows the specification of subclassifications for a PartOrUsageRelatedSpecification (e.g. different types of connector housings).
Specifies the allowed voltage range for the connector housing.
Defines the SealingType of the Terminal. This type always refers to the sealing of the terminal itself. However, even a terminal which is not sealable can be used in sealed locations with additional measures (e.g. on the slot).
Specifies the length of the terminal between the contact area (terminal reception) and the crimp are (wire reception, see diagram "Terminal Dimensions").
Specifies the overall length the terminal (see diagram "Terminal Dimensions").